Skip to content
Trending Topics: Research News•The Entomology Profession•Amazing Insects•Science Policy and Outreach

SLAM mosquito feeder housing and well

Published at 3000 × 2250 in DIY Mosquito Feeder: How to Feed Blood-Sucking Insects on a Budget

Overhead view of a green plastic square tray with a channel for an electrical cord on the bottom side. Next to the tray is a square piece of aluminum with a circular well carved into it. The aluminum tray is the correct size to fit into the housing.

The housing (left) is 3D printed and holds the aluminum well in place. A flat film adhesive heater is placed under the block to heat the blood. (Photo courtesy of Christopher Bibbs, Ph.D.)

Leave a Reply (Comments subject to review by site moderator and will not publish until approved.)

This site uses Akismet to reduce spam. Learn how your comment data is processed.